Golf repairs in Cork
The Importance of Checking Iron Lofts and Lies
Check you loft & lies |
Last week during a golf lesson the golfer asked about what can he do
about his 5 iron. “I can’t get it into the air” So I suggested we need to check
the lofts and the lies of his iron set.
We checked the irons using a Mitchell Steelclub Signature Angle Machine.
The results are in the table below.
Iron
|
Loft
|
Original Loft
|
Lie
|
Original Lie
|
4
|
24
|
24
|
60.5
|
60.0
|
5
|
22
|
27
|
61.0
|
61.0
|
6
|
29
|
31
|
60.5
|
61.5
|
7
|
32
|
35
|
60.0
|
62.0
|
8
|
36
|
39
|
61.0
|
63.0
|
9
|
40
|
43
|
62.0
|
63.5
|
PW
|
47
|
47
|
63.0
|
64.0
|
We can see immediately why the golfer was having trouble with his 5 iron. The loft of the 5 iron was 22 degrees, 2 degrees lower then his 4iron!! The 5 iron was hitting the ball further then the 4 iron, this creates a little problem with club selection. It also creates the further problem of a 7 degree gap between the 5 iron and the 6 iron, creating a big distance gap between both, compounding club selection problems.
The 6,7,8,9 irons are quite a bit stronger that the standard loft angles. But at least there's consistent gap between them. However there's a 7 degree gap between the 9 iron and the wedge, creating another distance gap problem between the 2 clubs.
We can also see the lies have changed a bit, giving the player some directional problems as well.
The solution in this case was straight forward. The clubs needed to be
adjusted back into the correct lofts and lies, giving the player a consistent
loft gap between the clubs and making club selection a lot easier. The correct
lie angles also would give the player straighter golf shots.
My case to point out to you is that you should check the lofts and the
lies of your clubs on a regular basis, especially if you play, practice quite a
bit, used forged clubs and play on firm turf. Getting the lofts and lies
checked doesn't take a whole lot of time! At John Dooley PGA we can provide
that service to you in a fast and professional manner. Bending them to correct
angles is also quick and is done for a nominal fee.
Any questions that you may have or comments that you need to make are
greatly appreciated.
Comments
Post a Comment